Maktec MT362 User Manual download pdf (Page 10)

DISASSEMBLING

[3] DISASSEMBLY/ASSEMBLY

[3]-5. Impact Bolt

Fig. 12

(7) Remove O Ring case and Impact bolt from Tool holder complete. (Fig. 12)

1. Insert (+) screwdriver into bit hole of

Tool holder complete and strike

the screwdriver with plastic hammer.

2. Now, the Impact bolt section is disassembled

from Tool holder complete. So, O ring 9 can

be replaced to the new one by removing it

from O ring case.

Note:

Do not reuse the removed Ring spring 28

if it is deformed or damaged.

Impact bolt

O ring case A

Ring spring 28

Sleeve 9A

Ring 10A

Cushion ring 12

O ring 9

ASSEMBLING

Fig. 13

(1) Insert Impact bolt section into Tool holder complete by following the order of illustlation below. (Fig. 13)

Cushion

ring 12

Ring 10A

O ring case

with O ring 9

Impact

bolt

Sleeve 9A

Face small diameter (9.0 mm)

side to Cap 35 side and insert

it into Sleeve 9A.

Cap 35 side

of Tool holder

Inner Housing side

of Tool holder

Cap 35 side

of Tool holder

Inner Housing side

of Tool holder

9.0

9.5

Tool holder complete

Face Flange side to Cap 35 and

mount it to Impact bolt.

Ring spring 28 will hold this

part in Tool holder.

Ring spring 28

Repair

P 10/ 19

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 18 19

Comments to this Manuals

No comments

Maktec MT362 User Manual Page 10

Comments to this Manuals

Related products and manuals for Power tools Maktec MT362